[RESOLVED] scanning between two local variables

Author: lalitpct@gmail.com (lalitpct)

I used below syntax and in both the case I don’t get result When I hardcode lv_tmp then I get correct result. message/info “filename : %%filename” message/info “lv_tmp : %%lv_tmp” scan filename,“%%lv_tmp”                       ;$result > 0 even though variable matches scan filename,lv_tmp                                ;$result > 0 even though variable matches scan filename,”/server/test/uat/report”  <– works fine   Can some one suggest which is the correct syntax

3 Comments

  1. What is the value of filename? And which exact Uniface version and patch level are you using? Thanks, Daniel Iseli Uniface Technical Support


    Author: diseli (daniel.iseli@uniface.com)
  2. Hi Syntax was coorect actuall there was new line character which was causing this issue. So I used rtrim to remove new line feed in the variable and then compared. Now its working fine.


    Author: lalitpct (lalitpct@gmail.com)
  3. Thanks for the info. It's good to hear that you've found the problem.


    Author: diseli (daniel.iseli@uniface.com)